Photovoltaic support U-beam strength calculation

How stiff is a tracking photovoltaic support system?

Because the support structure of the tracking photovoltaic support system has a long extension length and the components are D-shaped hollow steel pipes, the overall stiffness of the structure was found to be low, and the first three natural frequencies were between 2.934 and 4.921.

What is the design angle of a fixed photovoltaic module?

The software SAP2000 has strong functions, design of the fixed photovoltaic support. Japan. The deg ee of the design angle of PV modules was ×991 mm×40mm. The single photovoltaic array unit was arranged into 4 row s and 5 column s. According to the basic parameters were shown in table 1.

How many pillars does a photovoltaic support system have?

The tracking photovoltaic support system consisted of 10 pillars (including 1 drive pillar), one axis bar, 11 shaft rods, 52 photovoltaic panels, 54 photovoltaic support purlins, driving devices and 9 sliding bearings, and also includes the connection between the frame and its axis bar. Total length was 60.49 m, as shown in Fig. 8.

Can a solar array support structure withstand a wind load?

Even fixed solar array support structures have sofisticated design, that needs to be analyzed and often improved in order to withstand the wind load. The same applies of course to adjustable designs to an even greater extend. The analysis has to be carried out for many wind directions.

What are the dynamic characteristics of photovoltaic support systems?

Key findings are as follows. Dynamic characteristics of tracking photovoltaic support systems obtained through field modal testing at various inclinations, revealing three torsional modes within the 2.9–5.0 Hz frequency range, accompanied by relatively small modal damping ratios ranging from 1.07 % to 2.99 %.

What are the mechanical properties of a tracking photovoltaic support system?

In terms of the mechanical properties of the actual components of the tracking photovoltaic support system, the bar element and shell element were used to simulate different components: beam elements were mainly used to simulate the axis bar, photovoltaic support purlins and pillars. Shell elements were used to simulate the photovoltaic panel.