Photovoltaic inverter button instruction manual

What is the Aurora photovoltaic inverter installation and operator's manual?

Installation and Operator’s Manual Page 10 of 108 (PVI-3.0/3.6/4.2-OUTD-x-US Rev: 2.1) FOREWORD This document contains a technical description of the Aurora Photovoltaic Inverter which provides the installer and user with the information required for its installation, operation, and use.

How do I connect my inverter to a photovoltaic panel?

The electrical power and signals wiring from the inverter to the AC Grid and to the photovoltaic panel are connected through the Switch Box as described in Fig.11 SB-01 – "DC Switch Box Layout" –using the access windows in pos “A” for the power cables and the windows in pos “D” for the signal cables.

How do I Turn on a power inverter?

There are 2 submenus in the “History” menu: “Alarm” and “Running Status”. Manual Turn ON/OFF: Manual Power ON/OFF is required after regulation setting or manual (fault) shut-down. Touch to submenu “Turn ON/OFF”. Then move the cursor to “Turn ON” to start the inverter, the inverter will start up and operate normally if the start-up condition is met.

How does a photovoltaic inverter work?

After completing a set of electronics and safety auto-test routines, the inverter starts the grid connection process. As mentioned above, during this stage Aurora automatically tracks and analyzes the maximum power point (MPPT) of the photovoltaic field. Aurora indicates that insulation resistance was found to be too low.

How to turn on a PV inverter?

Make sure the DC open circuit voltage of input strings is less than 1000V. ) Turn on the AC circuit breaker. ) Turn on the DC circuit breaker. (Skip these two steps if there are no circuit breakers.) ) Switch the DC Switch to the “ON” position. When the energy supplied by the PV array is sufficient, the LED of inverter will light up.

How many inverters can a photovoltaic system handle?

The AURORA is capable of handling 2 separate arrays. If the output of photovoltaic system exceeds the capacity of a single inverter, additional Aurora inverters can be added to the system; each inverter will be connected to an adequate section of the photovoltaic field on the DC side and to the grid on the AC side.