Photovoltaic panel iron lock installation method diagram

How do I install a Klip-Lok roof?

Each row of modules is held to the roof using rails which are to be fastened by a number of Klip-lok clamp and L foot connectors. The rails can be laid out parallel to seams or perpendicular to the seams. Determine the appropriate installation area on the roof. Make sure the installation area to be center over the roof as much as possible.

How do you install a PV array on a roof?

Note: the PV array should not be installed closer than 500mm to the perimeter of the roof including ridge line and eaves (unless verified by a professional engineer). Attach the clamp and tighten the screw to 16 N.m using a 5mm Allen key or drill bit to roof per as planed plan position.

How do I connect a microinverter to a racking system?

Use IronRidge’s Microinverter Kit to bond compatible microinverters and power optimizers to the racking system. Insert Microinverter Kit T-bolt into top rail slot. Place compatible microinverter or power optimizer into position and tighten hex nut to 80 in-lbs. ➢ MLPe devices shall be installed near modules frames whenver possible.

How many PV panels will a Stan-Dard rail kit cover?

Used between PV panels to secure to Stan-dard Rail 1 kit will cover 2 PV panels within a row. Part number changes depending on panel required. Length of bolt depends on the thickness of the PV panel. Used on the first and last PV panel in a row 1 kit will cover the first and last PV panels in a row.

How do you install a ground lug fastener?

r prior to drilling the fastener in place.10.3.3 With an electric drill, screw the fastener in until it is fully screwed in a begins to clamp the ground lug in place. Do not vertighten or fastener failure may occur. Once the fastener has been fully thre lowing: 4-6 AWG wire: