How to install Chint photovoltaic bracket

How do you install a solar panel bracket?

The end brackets will have a spot to hold a single panel, and the middle brackets will have a spot to secure two panels. Some solar panel kits may use single panel brackets. The basic is to position the bracket to capture the panel and then tighten the bolt that clamps the bracket to the panel.

Why should I buy a CPS grid-tied PV inverter?

Thanks for choosing this CPS Grid-tied PV Inverter. This PV Inverter is a high performance and highly reliable product specifically designed for the North American Solar market. If you encounter any problems during installation or operation of this unit, first check this manual before contacting your local dealer or supplier.

How do I mount the CPS sca20/25ktl-do series inverter?

Manual mounting: Two people grab the handle positions marked in the Figure 3-8, and mount the inverter onto the bracket. CAUTION: The main housing of the CPS SCA20/25KTL-DO series inverter is about 46.5kg (≈102.5 pounds). Please ensure the mounting is properly installed before hanging the the inverter on the bracket.

How do I contact Chint power?

Web: Email: [email protected] Service Hotline: +86-21-37791222-6300 Address: Building 4, No. 3255, Sixian Road, Songjiang District, Shanghai, China Zip Code: 201614 SHANGHAI CHINT POWER SYSTEMS CO., LTD. All rights reserved. Specifications and designs included in this manual are subject to change without notice.

How to turn on a PV inverter?

Make sure the DC open circuit voltage of input strings is less than 1500V. ) Turn on the AC circuit breaker. ) Turn on the DC circuit breaker. (Skip these two steps if there are no circuit breakers.) ) Switch the DC Switch to the “ON” position. When the energy supplied by the PV array is sufficient, the LED of inverter will light up.

How do you mount a solar inverter?

Lift mounting: find the lifting eye bolt M10 (2pcs) in the Accessory Kit and screw them into the studs at the top of the inverter. Use sling rope or bar (inserted through both lifting eye bolts) to lift the inverter onto the bracket. The minimum angle between the two sling ropes should be less than 90 degrees (Figure 3-11).