Liquid Cooling Energy Storage Cabinet Wiring Diagram

How do I connect a liquid cooling package?

The cross section and the fusing of the connection cable may be found in Chapter 14.4, "Circuit diagram" in the operating and maintenance instructions. The Liquid Cooling Package is connected to the cold water network via two 3/4" threaded pipe connections on the inlet and return, located on the lower rear side of the unit.

What temperature should liquid cooling package be placed on a server enclosure?

The relative air humidity must be below 80%. Room temperature +22 °C at 50% relative air humidity, according to ASHRAE guidelines. - Interfering electrical installations (high frequency) should be avoided. Before the Liquid Cooling Package can be bayed onto the server enclosure, the following work should be carried out.

What is Vericom energy storage cabinet?

Vericom energy storage cabinet adopts All-in-one design, integrated container, refrigeration system, battery module, PCS, fire protection, environmental monitoring, etc., modular design, with the characteristics of safety, efficiency, convenience, intelligence, etc., make full use of the cabin Inner space.

How is the liquid cooling package connected to the cold water network?

The Liquid Cooling Package is connected to the cold water network via two 3/4" threaded pipe connections on the inlet and return, located on the lower rear side of the unit. The connecting pieces of both pipes are composed of T-joints, to allow for the option of connecting from the rear or through the raised floor.

What is a liquid cooled system?

A liquid cooled system is generally used in cases were large heat loads or high power densities need to be dissipated and air would require a very large flow rate. Water is one of the best heat transfer fluids due to its specific heat at typical temperatures for electronics cooling.

Can a liquid cooling package operate in emergency mode?

After turning on for the first time or after repair work, it is possible that the Liquid Cooling Package will operate in emergency operation mode. In order to switch the unit to normal operation (control operation), press down the "C" button (Fig. 12, Pos. 1) once quickly.