Which side of the generator wind temperature is the air intake

What temperature should a generator exhaust be recirculated?

Under fully loaded conditions, the temperature of flue exhaust from generator sets can be in excess of 900 F and the radiator (engine-driven or remote) discharge air temperature can be in excess of 160 F. Any recirculation of these high-temperature airstreams can cause the ventilation air temperature to exceed the ambient temperature.

How should a generator be ventilated?

Preferably, the source of ventilation air should be as low as possible and the air should flow over the entire generator set, thereby cooling the alternator, engine block, and radiator (for sets with unit-mounted radiators) to remove the after-cooler and jacket-water heat.

What is a diesel generator air intake & exhaust system?

The diesel generator air intake and exhaust system (DGAIES) provides the diesel engine with combustion air from the outside. The combustion air passes through a filter and silencer before being compressed by a turbocharger and cooled by the coolant system before entering the individual cylinders for combustion.

Does a generator intake need cool air?

It is important to note that cooling air is needed for more than just the engine; the generator intake also requires cool clean air. The most effective way to do this is to provide a ventilation air source low to the ground at the rear of the package.

What temperature should an engine room/enclosure be?

In all cases, engine room/enclosure design must ensure that air temperature around the engine will not exceed 50°C (122°F). Critical locations include the engine torsional damper and generator coupling. Air temperature reading should be taken no more than 6 inches away from these components.

How to remove radiated heat from a generator?

Radiated heat is removed with approximately half the airflow of a horizontal flow system. It is important to stretch the air curtain inlet the full length of generator set. Special care must be used to ensure adequate cool airflow at the generator air intake and at the generator coupling.