How to install the energy storage battery module box

How to install a battery module?

Use a torque of 6 N·m. 4.3 Pre-installation checks 4.3.1 Identifying model number Verify the model number of each battery module to ensure that they are all the same model. Installation 4.3.2 Measuring battery voltage Measure the voltage of each battery module. 1. Pull the groove to remove the cover from the power terminal compartment. 2.

How do I connect a battery module to a higher level system?

Insert one end of the cable into the RJ48 port on the lower part of each battery module, and insert the other end of the ca- ble into the RJ48 port on the upper part of the module positioned below it. Installation 4.5 Connecting power cables Connect power cables between the battery modules and the higher-level system via busbars.

How do you install a battery rack?

Fix the base assembly to the side beam. Fix the diagonal brace to the beams on both sides. Fix the base to the side or cross beam. Install the ground wire. Install the hanging lug on the battery module/high-voltage control box. Fix the battery module and the high-voltage control box on the rack. Adjust the height of the base and tighten the nut.

How often should a battery module be stored?

Battery Module Storage 1To ensure the battery service life, the storage temperature shall be kept between 0°C~35°C. 2The battery shall be cycled at least once every 6 months. the high-voltage control box of the DC connecting cable. This will interrupt the use of the self-discharging.

How do you connect a BMS to a battery pack?

Connecting the BMS: B- Terminal: Connect to the main negative (-) terminal of the battery pack. B+ Terminal: Often already connected internally; check your BMS specifications. B1 (or B0): Connect to the most negative point (first cell's negative terminal). B2, B3, ...: Connect sequentially to the positive terminals of each cell in series.

How do you install a battery pack on a wall?

es on th bracket and remove the assembled wallbracket.Drill 6 holes on the wall with Φ10mm drill W7 sleev or other tools for M4 flange, torque:1.6 Nm).Attach the wall bracket for expansion to the wall by ightening the screws with SW10 hexagon sleeve.Hold the handles on both sides of the battery pack and install the bat