Double clamp photovoltaic bracket installation sequence

How far should a clamp be connected to a PV module?

Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *Note: Need two support rails below the PV module to make sure the Mechanical load. *Note: The above-described distance is from the module edge to the middle of the clamp.

How do I install a double glass PV module?

Insert the PV module into the clamp, and make sure the module edge touch to the EPDM closely and then tighten the nut with uniform torque values using a qualified torque wrench to ensure the double glass module is firmly secured. Trina suggests using M8 bolts to affix the double glass modules onto the clamp.

How to install Trina Solar module with frameless clamps?

Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *Note: Need two support rails below the PV module to make sure the Mechanical load.

Which Racking clamps should I use for Trina Solar racking?

For C structure steel type 1 racking, due to the amount of space inside the racking section, many choices are available including T-shape nuts. Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module.

Can double glass modules be used in a photovoltaic system?

modules when installing double glass modules. Only authorized and trained personnel have access to install and maintain modules. battery in photovoltaic system. DO NOT replace parts of or all of the rooftop and wall materials by double glass modules. DO NOT touch any electric parts of double glass module.

How to install a PV module?

Remove the bottom connector parts. Connector parts : M8 Nut 、spring washer and washer. Put the clamp bolts into the installation holes, and then tighten the nuts. Insert the PV module into the clamp, and then tighten the nut. M8 ss304(16N· m~20N· m) Insert clamp into the connector racking.