Double clamp photovoltaic bracket installation and leveling

Where should clamps be connected to the PV module?

When the mechanical load pressure is ±2400Pa, Clamps should be connected to the module between 400 and 500mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *NOTE: We need two or three support rails below the PV module to make sure the module have a good mechanical load performance.

How do I install a double glass PV module?

Insert the PV module into the clamp, and make sure the module edge touch to the EPDM closely and then tighten the nut with uniform torque values using a qualified torque wrench to ensure the double glass module is firmly secured. Trina suggests using M8 bolts to affix the double glass modules onto the clamp.

How to install a PV module correctly?

In order to install the PV module correctly and obtain stable power output, please read the installation manual carefully before installing modules. DC current may generate when PV Modules are exposed to sunlight or other light source. At that time, please do not contact with electrical active parts. Front and back glass could protect solar cells.

How to install Trina Solar module with frameless clamps?

Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *Note: Need two support rails below the PV module to make sure the Mechanical load.

Can double glass modules be used in a photovoltaic system?

modules when installing double glass modules. Only authorized and trained personnel have access to install and maintain modules. battery in photovoltaic system. DO NOT replace parts of or all of the rooftop and wall materials by double glass modules. DO NOT touch any electric parts of double glass module.

Which materials should be used to install photovoltaic modules?

JA Solar recommends that when installing modules at the seaside, stainless steel or aluminum materials should be used to contact the photovoltaic modules, and the installation parts should be well protected from corrosion. The tilt angle of the modules is measured between the surface of the modules and a horizontal ground surface.